Set Up Instructions - Stamina 15-1310A Owner's Manual

SET UP INSTRUCTIONS

Place the 1310 Magnetic Upright Exercise Bike in the area where it will be used. It is recommended
that the 1310 Magnetic Upright Exercise Bike be placed on an equipment mat. The 1310 Magnetic
Upright Exercise Bike is approximately 33.8 inches long x 19.8 inches wide x 48 inches tall. (These
dimensions may vary up to one inch.) An area 4 feet wide x 5 feet long is required for safe operation of
the 1310 Magnetic Upright Exercise Bike. Make sure that adequate space is available for access to
and passage around the 1310 Magnetic Upright Exercise Bike.
LEVELING: Adjust the LEVELING CAPS(31) on the REAR STABILIZER(3) so that the 1310 Magnetic
Upright Exercise Bike sits on the floor without rocking.
MOVING: The 1310 Magnetic Upright Exercise Bike has a pair of wheels on the FRONT
STABILIZER(2). Grasp on the HANDLEBAR(6) and tip the 1310 Magnetic Upright
Exercise Bike forward to move.
FUNCTION INSPECTION:
Visually inspect the 1310 Magnetic Upright Exercise Bike to verify that assembly is as shown in the
above illustration. Check the function of the 1310 Magnetic Upright Exercise Bike by turning the
crank slowly through one complete revolution to verify that the drive train functions properly. Adjust the
TENSION KNOB(28) and verify that it functions properly and the resistance changes.
CAUTION: Locate and read the WARNING LABEL(64) on the 1310 Magnetic Upright Exercise Bike.
Make sure that all users read the WARNING LABEL(64) before using the product.
12
Equipment Mat
(not included)