Circuit Requirements; 110V Operation; Grounding; Extension Cords - Grizzly G8691 Instruction Manual

SECTION 2: CIRCUIT REQUIREMENTS

110V Operation

The Model G8691 is wired for 110V operation
only. The 1 ⁄ H.P. motor will safely draw 3.1 amps
2
at 110V. If you operate this lathe on any circuit
that is already close to its capacity, it might blow
a fuse or trip a circuit breaker. However, if an
unusual load does not exist and a power failure
still occurs, contact a qualified electrician or our
service department.
A 15-amp fuse or circuit breaker should be used
when fusing this wood lathe. Circuit breakers
rated any higher are not adequate to protect the
circuit from power surges.

Extension Cords

If you find it necessary to use an extension cord
with the Model G8691, make sure the cord is
rated Hard Service (grade S) or better. Refer to
the chart in the standard safety instructions to
determine the minimum gauge for the extension
cord. The extension cord must also contain a
ground wire and plug pin.

Grounding

In the event of an electrical short, grounding
reduces the risk of electric shock by providing a
path of least resistance to disperse electric cur-
rent. This tool is equipped with a power cord hav-
ing an equipment-grounding conductor. See
Figure 1. The outlet must be properly installed
and grounded in accordance with all local codes
and ordinances.
G8691 Wood Lathe w/ Stand
This equipment must be grounded. Verify
that any existing electrical outlet and circuit
you intend to plug into is actually grounded.
If it is not, it will be necessary to run a sepa-
rate 12 A.W.G. copper grounding wire from
the outlet to a known ground. Under no cir-
cumstances should the grounding pin from
any three-pronged
Serious injury may occur.
Figure 1. Typical 110V 3-prong plug and outlet.
Figure 2 Do not remove grounding pin.
plug be removed.
-5-