Maintenance; General; Maintenance General; Lubrication - Grizzly G8691 Instruction Manual

SECTION 6: MAINTENANCE

General

Regular periodic maintenance on your Model
G8691 Wood Lathe will ensure its optimum per-
formance. Make a habit of inspecting your lathe
each time you use it. Check for the following con-
ditions and repair or replace when necessary:
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
The non-painted surfaces on the Model G8691
should be protected against rust and pitting.
Wiping the lathe clean after every use ensures
that moisture from wood dust isn't allowed to trap
moisture against bare metal surfaces.
G8691 Wood Lathe w/ Stand

Lubrication

Since all bearings are shielded and permanently
lubricated, simply leave them alone until they
need to be replaced. Do not lubricate them.

V-Belt

Inspect regularly for tension and wear. Check pul-
leys to ensure that they are properly aligned.
Proper tension is indicated by no more than
deflection of belt when pushed lightly at a point
equally between the two pulleys.
Before performing any type of inspection or
maintenance work on this lathe, be sure
that the power cord is unplugged and all
moving parts have come to a complete
stop. Serious personal injury could occur.
1
⁄ "
4
-13-