Connecting; Connecting The Loudspeakers - Dynaudio Evidence Master Owner's Manual

Connecting

Fig. 2 Binding posts at rear of cabinet.
6
Connecting

Connecting the loudspeakers

1. Connect a two-pole (+/-) loudspeaker cable to the binding posts, located at rear of the
cabinet (see Fig. 2). The high quality, gold plated binding posts can accommodate
different connection systems:
– 4-mm-plugs ("banana plugs"):
without any tightening necessary.
– Cable spades: Un-tighten the binding posts, insert the spade into the opening, and
secure the spade by tightening the posts.
– Bare wires: Un-tighten the binding posts and place the cable into the binding
posts. Tighten the posts.
Note:
• With every connection system, ensure that the contact is tight and has a proper
contact area.
• Connectors with similar gold plating as the loudspeakers binding posts will typically
offer the best results and remain corrosion-free.
• Please ensure that the positive and negative cables do not make contact with each
other.
• Tighten the posts, and check the contact after a few days to make sure that it hasn't
loosened.
The pins can be put directly into the binding post
Dynaudio Evidence