Remote Control; Control Elements; Connecting The Loudspeakers; Connecting The Digital Signal Source - Dynaudio Focus 60 XD Owner's Manual

Owner's Manual Focus XD

Remote control

The remote control can be used to turn the loudspeakers on and off, change the volume,
switch between digital and analog input, switch the display on or off, and select a hub and
its connected signal sources.

CONTROL ELEMENTS

MUTE
ON/OFF
VOLUME
DIRECT
INPUT
1/2/3/4
HUB
A/B/C
14
Muting the loudspeakers
Briefly pressing this button will mute or unmute the selected
loudspeaker.
Loudspeaker on/off
= on. = switch to standby
Changing the volume
= louder. = quieter
Direct selection
= toggle between digital and analog input
= switch the display on/off
Selecting the signal source
Selects one of the signal sources Line In, Optical In, Coax In
or USB In from the active hub.
Selecting the Hub or Connect
Selects one of three possible Hubs or Connects A, B, or C.
dynaudio.com/focusxd
Connecting
►
To connect the loudspeakers, switch all components off.
the

Connecting the digital signal source

You can connect your loudspeakers as follows:
loudspeakers
•
Both loudspeakers are connected using cables. This requires two digital cables but the
systems benefits from signal processing of 24 bits/192 kHz.
•
You only connect one loudspeaker using a cable; the connection between the
loudspeakers is wireless. This requires one digital cable and provides signal processing
capabilities of 24 bits/96 kHz.
•
Both loudspeakers are operated wirelessly via a Dynaudio Hub or Connect box with
signal processing of 24 bits/96kHz.
Connecting both loudspeakers with cables
1. Connect the digital output for the signal source to the digital input (Digital Audio IN) on
one loudspeaker. You can choose whether to use the right or left loudspeaker.
2. Operate the connected loudspeaker as master by setting the Channel Mode switch on
the rear side of the housing to Master.
3. Connect the digital output on the master loudspeaker to the digital input (Digital Audio
IN) on the other loudspeaker.
4. Operate the loudspeaker connected in this step as slave by setting the Channel Mode
switch on the rear side of the housing to Slave.
Remote control / Connecting the loudspeakers
Connecting the digital signal source.
15