Connecting The Loudspeakers - Dynaudio IP17 User Manual

Connecting the loudspeakers

Figure 1: Binding posts at rear of cabinet (example)
Connect a two-pole (+/-) loudspeaker cable to the binding posts, located at rear of the cabinet (see Figure 1). The
high quality, gold plated binding posts can accommodate different connection systems:
▪ 4.0 mm banana plugs: The pins can be put directly into the binding post without any tightening necessary.
▪ Cable spades: Untighten the binding posts, insert the spade into the opening, and secure the spade by tightening the
posts.
▪ Bare wires: Untighten the binding posts and place the cable into the binding posts. Tighten the posts.
Note
▪ With every connection system, ensure that the contact is tight and has a proper contact area.
▪ Connectors with similar gold plating as binding posts will typically offer the best results and remain corrosion-free.
▪ Please ensure that the positive and negative cables do not make contact with each other. Tighten the posts, and check
the contact after a few days to make sure that it hasn't loosened.
10 Passive Speakers User manual