KVH Industries M5 User Manual page 21

Manual Trisat Mode
When the TracVision M5/M7 system is set to Manual TriSat Mode, a
TriSat group is selected, allowing you to switch between the satellites
within the group with a single button press.
TIP: TriSat groups and the satellites within each TriSat group are shown in
Figure 2-5 on page
Figure 2-6 Switching Satellites Using Manual TriSat Mode
Tracking <SAT A>
<SAT B>
Select
Satellite B
DualSat Mode
Most TracVision M5/M7 system configurations allow automatic
satellite switching in DualSat Mode. When automatic switching is
enabled, satellite switching occurs automatically while the user
changes channels using the receiver's remote control. You can also use
the MCP to manually switch between your selected pair of satellites
with a single button press.
NOTE: If you use the MCP to manually switch satellites, automatic satellite
switching is disabled until the system is turned off, then turned back on. For
more information on turning the system on/off, see
On/Off" on page
Figure 2-7 Switching Satellites Using DualSat Mode
Tracking <SAT A>
<SAT A>
16.
Selected
Satellite
Menu <SAT C>
Select
Satellite C
14.
Selected
Satellite
Menu <SAT B>
Select
Satellite B
TracVision M5/M7 User's Guide
Chapter 2 - Operation
"Turning the System
17