Table of Contents
Advertisement
PPPoE
If your DSL provider says that you are connecting through PPPoE, perform these steps:
a.
Enter the User Name
b.
Enter the Password
c.
Reenter the password
d.
Enter the Service Name if your ISP requires it. This is optional.
e.
Keep the value of MTU as default setting.
Note: MTU (Maximum Transmission Unit) is the largest frame size that can be transmitted over the
network. Messages longer than the MTU must be divided into smaller frames.
f.
To change the maximum idle time, enter a new value in minutes. This determines how long the Router
keeps the Internet connection active after there is no Internet activity from the LAN. Enter a value of
zero means never log out.
g.
By checking the box next to Auto-reconnect, the Router will automatically connect to Internet if you
are disconnected.
Important: If you enable PPPoE, remember to remove any PPPoE applications already installed on any of
your PCs.
802.11g Wireless Router User's Manual
16
Advertisement
Table of Contents
Need help?
Do you have a question about the IEEE 802.11g Wireless Router and is the answer not in the manual?
Questions and answers