Setting Operation Mode; Setting Operation Mode - Daikin DCS302C71 Operation Manual

n Setting operation mode (Fig. 12)
[Registration]
1.
Press the OPERATION MODE SELEC-
TOR BUTTON. Each time you press this
button, the display rotates as shown on
the below list.
• List of operations which can be set
In the below list, " V " refers to the acceptable set-
ting, while " × " refers to the not acceptable setting.
English
∗1: Setting may not be acceptable depending on the
type of indoor unit with which this unit is connected.
∗2: In zone control, the units run in temperature adjust-
ment mode (heating or cooling) for the outdoor sys-
tem for the groups registered to those zones.
Heating or cooling selection is not available.
*3: or or
Changing the ventilation mode cannot be done in
the zone screen. Changing the ventilation mode
should be done in the individual screen.
∗4: In group control, the units run in temperature adjust-
ment mode (heating or cooling) for the group outdoor
system. Heating or cooling selection is not available.
• The Zone consists of the following two cases.
A. Zone without display"
The group with master remote controller setting
exists in this zone.
Setting the master remote controller enables cool/
heat selection.
Operations other than cool/heat operations can also
be set for some operations. For further details, see
the list on the left.
B. Zone with display"
No group with master remote controller setting
exists in this zone.
The cool/heat selection is not available because the
master remote controller has not been set.
Some operations other than cool/heat operations
can be set. For further details, see the list in the left.
See page 20 if the display"
• Fan operation can be performed for each zone
using the central remote controller even if there is no
cooling/heating selection right during cooling or
heating. Also, if a Ventiair is connected in the zone,
ventilation and ventilation cleaning operation is pos-
sible. See the included operating manuals for
details.
• When the indoor unit is in heat operation, change the set-
ting to FAN operation through the central remote control-
ler; then, you can switch the fan speed to the extremely
low fan speed. Warm air may blow if any other indoor unit
belonging to the same system is in heat operation.
• The indoor fan stops during defrost/hot start.
• DRY cannot be set from the central remote controller.
"
"
" is flashing.
16