Changing The Fan Direction And Fan Strength; Changing The Ventilation Mode And Ventilation Strength; Timer Number Setting - Daikin DCS302C71 Operation Manual

n Changing the fan direction and fan
strength (Fig. 8)
This changes the fan direction and strength settings in
the air conditioner.
Changing the fan direction and strength is done in the
individual screen.
[Registration]
1.
Press the "ALL/INDIVIDUAL button"
to enter the
The unit will enter the individual screen automati-
cally if nothing is done for one minute.
2.
Using the arrow keys,
to select the units to fan direction
" "
adjustment or fan strength adjustment.
Keeping the button pressed down will move it
rapidly.
3.
Press the "FAN DIRECTION ADJUST-
MENT" button.
This sets "fixed" or "swing" for the fan direction.
Press the "FAN STRENGTH ADJUST-
MENT" button.
Pressing this button scrolls through "
and " ".
Depending on the indoor unit, only "
may be available.
The functions included in the indoor units may vary.
Pressing a button for a function which is not available
will cause "NOT AVAILABLE" to be displayed.
n Changing the ventilation mode and
ventilation strength (Fig. 9)
This changes the ventilation mode and strength set-
tings in the total enthalpy heat exchanger.
Changing the ventilation mode and strength is done in
the individual screen.
[Registration]
1.
Press the "ALL/INDIVIDUAL button" to
enter the individual screen.
The unit will enter the individual screen automati-
cally if nothing is done for one minute.
2.
Using the arrow keys,
to select the units to ventilation
" "
mode or ventilation strength adjustment.
Keeping the button pressed down will move it
rapidly.
11
individual screen.
move the
", "
" and "
move the
3.
Press the "VENTILATION MODE"
button.
It will scroll through "
→ "
Press the "VENTILATION STRENGTH
ADJUSTMENT" button.
It will scroll through "
"
The fresh up function may not be available
depending on the connected unit model.
The functions included in the indoor units may vary.
Pressing a button for a function which is not available
will cause "NOT AVAILABLE" to be displayed.
• Ventilation Mode and Amount
If these are changed using the remote controller
depending on the unit model, they cannot be dis-
played on the central remote controller.
To monitor the ventilation mode and amount, check
the values on the remote controller.
n Timer Number Setting (Fig. 10)
",
(Only when used with the schedule timer)
Using this together with the schedule timer makes it
possible to set on and off times four times a day.
"
[Registration]
1.
Pressing the "TIMER NO." button
causes the number set for timer number 1
to blink.
If no timer setting has been made
" " will be displayed.
Select the desired timer number
by pressing the
NO." button.
2.
Once the desired timer number is
displayed, press the "SET" button.
Press the
within 10 seconds after the timer
number is displayed.
The display will return to how it
was after 10 seconds.
The display for timer number 1
will stop blinking and then timer number 2 will start
blinking.
" → "
".
" → " " → "
" → "
".
"TIMER
"SET" button
" → "
"
" →
English