Installing Your New Cooker - Euromaid F54CW User Manual

Installing your new cooker

Safety warnings about installation
• The cooker MUST BE installed and serviced only by
an authorised person.
• A certificate of compliance must be supplied by
installer and is to be kept by the customer.
• The packing materials must be removed before you
install the cooker.
• You must follow the installation instructions in this
booklet.
• The surrounding kitchen cabinets MUST BE able to
withstand 95°C. We will not accept responsibility
for damage caused by installation in to kitchen
cabinets which cannot withstand 95°C.
• The appliance must not be installed in a corner. It
must be installed at least 100mm from the side wall.
• The flexible pipe for gas models must have sufficient
loops so the cooker can be moved for service.
• The vents; openings and air spaces MUST NOT be
blocked.
• The anti-tilt floor bracket must be installed to avoid
accidental tipping.
• The stability bolt must be installed to avoid
accidental moving.
• You must not pull the cooker by the door handles.
• Power socket, if provided for gas models, and
electricity isolation switch for electric models and
gas models without a 20A plug, is to be installed
in an accessible position near the cooker (but not
behind cooker).
• If the supply cord or cable is damaged, it must be
replaced by an approved service agent or a similarly
qualified person in order to avoid a hazard.
Unpacking and installation Instructions
for Installer
Unpacking
• Please check the product and make sure that there
is no damage.
• Read the relevant Installation Sections of this
Manual relating to your Model and type of cooker.
• Confirm that product is compatible with available
electrical / gas supply. Ensure proposed installation
position does not conflict with Installation Sections.
• Check the attachment packing in good condition,
complete accessories.
• Use screw driver to remove Anti-tilt floor bracket
screwed onto the rear of the cooker.
Euromaid 540mm Upright Cooker INSTALLING YOUR NEW COOKER 27
Packaging of
Front control models
Packaging of
Rear control models