Introduction To The Hardware; System Requirements - Navibe Mercury 100 User Manual

1.4 Introduction to the Hardware

Power/Mode
select button
Start/Stop/Mark/Reset
1. Power/Mode select button: Use to turn power on（Hold on 1sec）/off（Hold on 3sec）
and switch between operating modes（Push）.
Select/Adjust button: Switch display functions / configure parameters （Push） and setup
2.
mode（Hold on 3sec）.
3. Start/Stop/Mark/Reset button: Turns the recorder（Push）/backlighton/off（Hold on
3sec）, marks locations and resets parameter settings（Push）.

1.5 System Requirements

Please check that your computer meets the following system requirements before installing
the driver program and software bundled with this product.
1. Pentium III 8000MHz CPU or above
2. USB Interface
3. 512MB RAM
4. CD-ROM drive
5. Windows Vista(service pack 1)/XP/2000 operating system
6. Network bandwidth download and upload upward 2M
USB Port
7
Select/Adjust button