Route Mode Setup - Navibe Mercury 100 User Manual

6.6.3 Route Mode Setup:

distance reading. By pressing the "Reset/Mark" button (i.e. "Start/Stop"
button), the destination will be reset and it's coordinates marked. The calculated DTG
should be 0.00. Once reset, it will continue blinking.
Pressing the "Select" button a second time
Blinking items include: MI or KM, mi/h or km/h. If MI is blinking, then mi/h will be blinking as
well. If KM is blinking, then km/h will be blinking. Pressing the "Reset/Mark" button (i.e.
"Start/Stop" button) switches between metric or imperial units and they will continue to blink.
If the unit of measurement is switched to imperial or metric, other functions' unit of
measurement will switch as well.
Pressing the "Select" button a third time
Reverts to the first blinking item.
Under any setup mode, holding down the "Select" button for 3 seconds closes the setup
mode and display then reverts back to user mode.
In Route mode (destinations 01~50), holding down the "Select"
button for 3 seconds opens the
destination (01~50) will also start blinking. For example, if
currently set to destination ID 21, the number 21 will flash
during Setup mode. The blinking items include
40
display. The current
, DTG and