Waypoint Mode - Navibe Mercury 100 User Manual

6.3 Waypoint Mode

In Bike mode, press the "Power" button switches to Waypoint mode. At startup, waypoint A
is displayed. Press the Select button to cycle through waypoints A~D. When the "Power"
button is pressed to exit or access this mode, it will remember which waypoint (A~D) was
last displayed.
Set Waypoint
Holding down the "Select" button for 3 seconds, opens the
current waypoint blink. For example, if waypoint B is currently displayed, waypoint B along
with DTG and
"Reset/Mark" button (i.e. "Start/Stop" button) resets the waypoint. The DTG for the newly
marked waypoint should be 0.00. Now hold down the "Select" button for 3 seconds to close
the Setup mode and
wish to ride to waypoint B, it will direct you to the marked waypoint. Marking a new waypoint
will override the previously marked waypoint.
When the rider is within 50m of waypoint A, B, C or D, a buzzer will sound 5 times (lasting 1
second each time at 0.5 second intervals). The arrow will also blink each time the buzzer
sounds. The user can press any button to stop the buzzer or wait for it to finish and the
arrow will continue blinking. When within 10m of the waypoint, all eight points of the
compass icon will start blinking and only revert to normal when the rider is more than 10m
away from the waypoint.
This item can only be calculated or displayed when GPS coordinates are available. When
GPS fix has not been acquired, time is shown as --:--:--, distance as ---- and speed as ---. If
speed is less than 5km/hr, time is shown as --:--:--.
(1) Estimated time of arrival shown as TOA.
(2) Estimated direct line distance shown as DTG in MI
or KM.
(3) Current speed, shown as mi/h or km/h.
(4) Arrow pointing towards the destination.
distance display will start blinking. Pressing the
display. The waypoint has now been set and the next time you
35
display and makes the