Lcd Icon Guide - Navibe Mercury 100 User Manual

5. LCD Icon Guide

1. Battery: Divided into 3 blocks. During normal use, this shows the amount of
power remaining. When charging, the blocks cycle from the bottom up, going from
0 to 3 blocks. Once fully charged, the icon stays at 3 blocks.
2. Satellite: Indicates the GPS positioning status. Blinking means no fix or
scanning for satellites. Constant means position acquired or still acquiring fix.
3. Time: Shows the cumulative riding time. When Reset to 00:00:00, it will start
counting riding time when the user starts riding (reaches 5km/hr). If riding time
exceeds 99:59:59, it hold to 99:59:59.
4. TOA: Time of Arrival. When switched to Waypoint and Route display mode, it
shows the estimated time of arrival.
5.
：Shows the time for the current region. Taiwan, for example, must be set to
6.
UTC +8hr based on the GPS reference time. If GPS fix not acquired, then the time
display changes to --:--:--.
7. DTG: Distance to GO. When switched to Waypoint and Route display modes,
shows the estimated direct line distance.
8. ODO: Odometer. Shows the current distance traveled in MI (miles) or KM
(kilometers).
9. DST: Distance. Displayed in MI or KM. Resets to zero when device is turned on or
off.
10. AZM: Azimuth. Reads the current azimuth from the e-compass and displays it in
：Time display.
29