Page 1
P4389005 Escale Wall Hung Bidet Installation and User Guide MODEL NUMBERS 19046W Important :- Please quote the above model number(s) when ordering spares. IMPORTANT! Installer: This manual is the property of the customer and must be retained with the product for maintenance and operational purposes.
1040458-K01-A DESCRIPTION The Kohler Bidet is designed for connection to a hot and cold water supply. This installation and user guide covers the Escale wall mounted vitreous china bidet. SAFETY : WARNINGS Kohler products are precision-engineered and should give continued...
1040458-K01-A SPECIFICATION Plumbing Connections Hot (H) and Cold (C) inlets must be connected to the correct inlet supplies. INSTALLATION Before You Begin Turn off the water supply. Before installation carefully inspect the new fixture for any signs of damage.
1040458-K01-A Install the Bidet Install the services. Make sure that the hot and cold water supply pipes and the waste are installed correctly. Note! The hot and cold water supplies must be installed with isolating valves. Fit the taps to the bidet in accordance with the manufacturer’s instructions.
Page 7
1040458-K01-A Grub Screw Access Hole Plastic Fitting Chrome Concealing Attachment Bolt P4389020 Apply silicone sealant or a sand and cement mixture to the back of the bidet. Sealant / Sand and Cement P3955050 10. Loosen the grub screws with the tool provided in the component pack and position the bidet on the wall.
1040458-K01-A Install the Plumbing COLD Tap Connections Waste P3955080 Install the drain in accordance with the manufacturer’s instructions. Connect the taps to the water supply. Open the hot and cold water valves, and check the supply connections for leaks. Run water into the bidet, and check the drain connections for leaks.
1040458-K01-A USER MAINTENANCE Cleaning Caution! Risk of product damage. Many cleaners contain abrasive and chemical substances, and should not be used for cleaning stainless steel, enamel, plated or plastic fittings. These finishes should be cleaned using a mild washing up detergent or soap solution, rinsed and then wiped dry with a soft clean cloth.
1040458-K01-A CUSTOMER SERVICE Limited One-year Warranty Kohler plumbing fixtures and fittings are warranted to be free of manufac- turing defects. Kohler Co. will, at its election repair, replace, or make appropriate adjust- ment where Kohler Co. inspection discloses any such defects occurring in normal usage within one year after installation.