Front Panel - American Audio VMS2 User Manual

(19) Shift – Enables secondary MIDI commands on buttons and jog wheels. Example: Press
Shift and Vinyl to activate Keylock.
(20) Pitch Slider – This slider is used to adjust the playback pitch percentage. The slider is a
set adjustment and will remain set until the pitch slider is moved or the pitch function has
been turned off.
12.2 F P
RONT ANEL
M S (21-23)
IC ECTION
The VMS2™ is equipped with a microphone input, easy to use, no ASIO routing required. The
microphone channel has an independent On/Off switch, Gain control, and Tone control.
(21) Mic On/Off – Turns the microphone on and off. When your microphone is on, the
button will be backlit by a red LED.
(22) Mic Gain Control – Increase or decrease the microphone signal level.
(23) Mic Tone – Adjust the vocal tone on the microphone input.
M C (24-25)
IXER ONTROLS
The VMS2™ can be used as a MIDI control, a standalone mixer, or in combination giving you
maximum control of your music collection whether it be on vinyl, digital CD's or Computer DJ
software (Virtual DJ included).
(24) USB/Analog Switch – These will switch the corresponding channel from USB audio
stream or analog audio input. USB will route the software assigned ASIO audio channel thru
the corresponding MIDILOG channel. Analog will route the analog audio input from the rear
panel thru the corresponding MIDILOG channel.
(25) Normal/Reverse (Crossfader Mode) – Switches the crossfader from normal to reverse
mode. In reverse mode the CF A assignments will be on the right of the crossfader and the
CF B on the left.
(26) Cue/Master Knob – Sets the headphones output from Cue or Master. When set to the
Cue position, the headphones will receive the signal from any and all channels with the Cue
button activated. When set to the Master position, the headphones will receive the pre
©American Audio® - www.americanaudio.eu VMS2™ User Manual Page 24