American Audio VMS2 User Manual page 26

MIDILOG 1 & 2: Phono/Line level RCA inputs are used to connect turntables, CD
players, MP3 players, or other line level sources. The type of input must directly reflect
the selected mode of the Line/Phono Selector Switch. Turntables equipped with MM
pickup cartridges (All DJ turntables use MM pickup cartridges) may be connected to
these jacks as long as the Line/Phono Selector Switch is in the Phono position. CD
players, MP3 players, and other line level instruments may only be connected to these
jacks as long as the Line/Phono Selector Switch is in the Line position.
(35) Phono Ground – Be sure to connect turntable ground leads to either or both of the two
available ground terminals. This will reduce the humming and popping noises associated
with magnetic phono cartridges.
(36) MIC – XLR and 1/4" combo jack for microphone connection. The volume output level for
the microphone will be controlled by its own respective volume knob.
(37) Line/Phono Selector Switches – These switches are used to change the voltage line
levels of their respective Line/Phono RCA inputs jacks. When connecting turntables with
magnetic cartridges to these jacks, be sure the corresponding switch is in the Phono
position; and when using line level input devices be sure this switch is in the Line position.
(38) USB Port – Connect here to your PC for MIDI interface and USB interface (audio ins and
outs).
(39) Power Supply – The power supply is not required, but the headphones may be
underpowered, and there is an increased chance of audio distortion.
©American Audio® - www.americanaudio.eu VMS2™ User Manual Page 26