Set-Up; Checking The Contents; Installing The Units; Connections - American Audio VMS2 User Manual

10. S -U
ET P
10.1 C
HECKING THE
Be sure your VMS2™ was shipped with the following:
VMS2™ Controller
Operating Instructions (This Booklet)
USB Cable
6V Power Adapter
Virtual DJ Software
Warranty card
10.2 I
NSTALLING THE
Place your unit on a flat surface or mount it in a secure rack mount case.
Be sure the player is mounted in a well-ventilated area where it will not be exposed to
direct sunlight, high temperatures, or high humidity.
Try to place the unit as far as possible from TVs and tuners, as the unit may cause
undesirable interference.
10.3 C
ONNECTIONS
Be sure main power is connected last to prevent any electrical damage.
A C
UDIO ONNECTIONS
Use RCA or XLR cables to connect the VMS2™ outputs to powered speakers or an amplifier.
Never connect this player's output to a mixers Phono inputs.
Caution: To avoid severe damage to the unit, be sure the power is off when making
connections to the unit.
©American Audio® - www.americanaudio.eu
C
ONTENTS
U
NITS
VMS2™ User Manual Page 18