Brother DCP-6690CW User Manual page 88

Error Message
No Paper Fed
Out of Memory
Paper Jam
Touchscreen
initialization
failed
Unable to Clean XX
Unable to Init. XX
80
Cause
The machine is out of paper or
paper is not properly loaded in the
paper tray.
The paper is jammed in the
machine.
The outer rear cover or the inner
rear cover may not be closed
properly.
The machine's memory is full.
The memory card or USB flash
memory drive you are using does
not have enough free space to
scan the documents.
Paper is jammed in the machine.
The Touchscreen has been
pressed before the power on
initialisation has completed.
The machine has a mechanical
problem.
— —
OR
A foreign object such as a clip or
ripped paper is in the machine.
The machine has a mechanical
problem.
— —
OR
A foreign object such as a clip or
ripped paper is in the machine.
Action
Do one of the following:
Refill the paper in the paper tray, and
then press Mono Start or
Colour Start.
Remove the paper and load it again
and then press Mono Start or
Colour Start.
See Printer jam or paper jam on page 82.
Open the outer rear cover and inner rear
cover, and then close them securely.
When copy oparation is in progress, press
Stop/Exit and wait until the other
operations in progress finish and then try
again.
Delete unused files from your memory card
or USB Flash memory drive to make some
free space and then try again.
Open the Outer Rear Cover and Inner
Rear Cover (at the back of the machine)
and remove the jammed paper. (See
Printer jam or paper jam on page 82.)
See Printer jam or paper jam on page 82.
Make sure the paper length guide is
adjusted to the correct paper size. Do not
extend the paper tray when you load A5 or
smaller size paper.
Unplug the machine from the power or turn
the machine off. Make sure that there is
nothing resting on or touching the
Touchscreen. Plug the machine back into
the power or switch the machine on. Wait
until the menu button appears before
attempting to use the Touchscreen.
Open the scanner cover and remove any
foreign objects inside the machine. If the
error message continues, disconnect the
machine from the power for several
minutes, then reconnect it.
Open the scanner cover and remove any
foreign objects inside the machine. If the
error message continues, disconnect the
machine from the power for several
minutes, then reconnect it.