Brother DCP-6690CW User Manual page 87

Error Message
Cannot Print
Cover is Open.
Data Remaining
Document Jam
High Temperature
Hub is Unusable.
Image Too Long.
Image Too Small.
Ink low
Low Temperature
Media Error
Media is Full.
No Cartridge
No File
Cause
One or more of the ink cartridges
are empty. The machine will stop
all print operations.
The scanner cover is not closed
completely.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The document was not inserted or
fed correctly, or the document
scanned from the ADF was too
long.
The print head is too warm.
A Hub or USB Flash memory
drive with Hub has been
connected to the USB direct
interface.
The proportions of your photo are
irregular so effects could not be
added.
The size of your photo is too small
to trim.
One or more of the ink cartridges
are running out of ink.
The print head is too cold.
The memory card is either
corrupted, incorrectly formatted,
or there is a problem with the
memory card.
The memory card or USB flash
memory drive you are using
already contains 999 files.
An ink cartridge is not installed
correctly.
The memory card or USB Flash
memory drive in the media drive
does not contain a .JPG file.
Troubleshooting and Routine Maintenance
Action
Replace the empty ink cartridges. (See
Replacing the ink cartridges on page 85.)
Lift the scanner cover and then close it
again.
Firmly close the ink cartridge cover until it
clicks.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
See Using the ADF on page 22.
See Document jam on page 82.
Allow the machine to cool down.
A Hub or USB Flash memory drive with
Hub are not supported. Unplug the device
from the USB direct interface.
Choose a regularly proportioned image.
Choose a larger image.
Order a new ink cartridge.
Allow the machine to warm up.
Put the card firmly into the slot again to
make sure it is in the correct position. If the
error remains, check the media drive (slot)
of the machine by putting in another
memory card that you know is working.
Your machine can only save to your
memory card or USB flash memory drive if
it contains less than 999 files. Try deleting
unused files to free some space and try
again.
Take out the new ink cartridge and re-
install it slowly until it clicks. (See
Replacing the ink cartridges on page 85.)
Put the correct memory card or USB Flash
memory drive into the slot again.
B
79