Assembling And Hanging The Fan - Hunter Ceiling Fans Installation And Operation Manual

3 • Assembling and Hanging the Fan
Standard
Mounting
Washer
Step 3-1
Steps 3-2 – 3-5
6
Adapter
Cover
Hunter Fan Company
You can assemble your fan for standard or angle mounting.
Label
3-1. Remove the label from the standard mounting washer inside the
canopy. Leave the washer in place. (Note: You will not use the
washer included in the parts sack.)
3-2. To assemble the fan to hang down from a flat or angled ceiling,
insert the downrod through the canopy, canopy trim ring, and
adapter cover.
3-3. Feed the wires from the fan through the downrod.
3-4. Screw the downrod into the fan assembly.
3-5. Align the hole in the adapter cover with the set screw. Tighten the
allen head set screw using the included allen wrench.
Canopy
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
Downrod
3-6. Raise the fan and place the ball into the hanger bracket.
3-7. Align the notch on the ball with the indent in the hanger bracket.
Canopy
(Rotate the fan until you hear the notch pop into place.)
(with Washer)
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Canopy
Trim Ring
Set Screw
Steps 3-6 – 3-7
Indent
42002-01 • 10/12/05