Menu Map - Chauvet Legend 1200E SPOT User Manual

Menu Map

Main Function Sub Function
DMX Address
DMX Channel Mode
DMX Functions
View DMX Value
Pan Inverse
Tilt Inverse
Bl.o. P/T Moving
Fixture Settings
Bl.o. Color Change
Bl.o. Gobo Change
Auto Focus
On/Off
State/Power On
Off Via DMX
On if DMX On
Off if DMX Off
Lamp Settings
Cooling Mode
Ignition Delay
Low Power Delay
Display Inverse
Back Light Auto Off Yes/No
Display Settings Back Light Intensity 1~10
Temperature Unit
Auto Test
Fixture Test
Manual Test
Fixture use time
Fixture
Lamp On Time
Information
Firmware Version
Pan & Tilt
Color
Gobo & Iris
Reset Function
Shutter & Dimmer
Focus & Zoom
Prism & Frost
All
Fixture
Maintenance
Special
Functions
Factory Settings
Legend™ 1200E Spot User Manual
Selection Instruction
1~512 DMX starting address assignment
Mode 1 (23) Operating mode: Basic
Mode 2 (31) Operating mode: Advanced
View the DMX input values (only from the starting address
through the last channel of the mode (23/31)
Yes/No Inverts the Pan operation from 540 ~ 0
Yes/No Inverts the Tilt operation from 270 ~ 0
Yes/No Enables Blackout while pan/tilt moving
Yes/No Enables Blackout while Color moving
Yes/No Enables Blackout while Gobo moving
Yes/No Enables auto focus while zooming narrow/wide
On/Off Manual Control of the lamp state
On/Off Automatically strikes the lamp upon powering on the fixture
Yes/No Allows remote Lamp Off commands to be received via DMX
Yes/No Strikes the lamp if DMX is present
Yes/No Turns off the lamp if DMX is not present
Maintains the fans at highest speed, regardless of lamp
High
temperature
Maintains the lowest (most silent), possible fan speed, according
Auto
to the lamp temperature
0s~255s Delays striking the lamp to allow for lower inrush currents
Sets the time activating delay between the shutter/dimmer
0s~255s closing and the lamp power reduction. The maximum delay is
255 seconds
Yes/No Inverts the display graphics 180°
Turns off the backlight after several seconds of being idle
Sets the backlight intensity from dim to bright
°C Displays the temperature in Celsius
°F Displays the temperature in Fahrenheit
Runs the fixture, testing each function in series
Manually controls each function of the fixture directly from the
control panel without a DMX controller; used for
testing/troubleshooting purposes only
Displays the amount of time the fixture has been operating
Exit Exits this function
Resets the lamp time (used when replacing the lamp in the
Reset Time
fixture)
Displays the firmware version of each software chip
Yes/No Resets the pan & tilt, independent of the other motors
Resets the color wheel, CMY, & 3200 K (CTO) dichroic flags,
Yes/No
independent of the other motors
Yes/No Resets the gobo & iris, independent of the other motors
Yes/No Resets the shutter & dimmer, independent of the other motors
Yes/No Resets the focus & zoom, independent of the other motors
Yes/No Resets the prism & frost, independent of the other motors
Yes/No Resets all motors in the fixture simultaneously
Interval User can set the custom time for this Warning message
Remain Time Shows the time remaining from the current interval user time
Resets all settings to the factory defaults, with the exception of
Yes/No
the motor offset settings
17
Operating Instructions
8/13/2009 10:57 AM