Table of Contents
Advertisement
7-8 Recording with External VCR Activation Signal
Recording start/stop can be controlled externally by inputting a VCR activation signal to the [SERIES/CLOCK IN] terminal on
the SR-L911US's rear panel.
To [COM] terminal
Connection
VCR control signal (ground signal)
Start of recording
Operation
VTR MODE 2
(SUMMER TIME)
TERMINAL
(TERMINAL SEL 1)
(TERMINAL SEL 2)
SEL 1
(REC REMAIN)
(CAMERA SW)
PRESS (SHIFT, SET)
PRESS (MENU)
TO
VCR mode 2 setting screen
• When the [TIMER] indication is lit or the function is lit
or the function menu switch [TAPE END MODE] on
the VTR mode 1 setting screen is set to "REPEAT",
this function is disabled.
• If a VCR activation signal is input while the unit is
already recording (started with the [REC] button),
recording continues and stops when the activation
signal is no longer input.
• Recording is performed in the time mode set with the
[TIME MODE] button.
36
Rear panel
To [SERIES/CLOCK IN] terminal
LV: 0 V
Stop or power off
OFF
EXT
Set to EXT.
WARN
(External
OFF
recording
OFF
function)
END
External control
equipment
Connect the [SERIES/CLOCK IN] terminal and [COM]
terminal on the SR-L911US's rear panel to the external
control equipment.
Set the function menu switch <TERMINAL SEL 1> to
1
"EXT" to use the external recording function.
Press the MENU button to switch the on-screen display
2
to the time/date display.
Load a cassette with a safety tab in place and engage
3
the Stop mode, the Pause mode or turn the operating
mode off.
• When a VCR activation signal (ground input) is input to
the rear panel's [SERIES/CLOCK IN] terminal,
recording starts automatically and continues for as
long as the activation signal is input.
When the activation signal stops, the Stop mode is
engaged.
• When the activation signal is input again, recording
starts.
Advertisement
Table of Contents
