Recording With External Vcr Activation Signal - JVC SR-9240E Instructions Manual

7 RECORDING

7-8 Recording with External VCR Activation Signal

Recording start/stop can be controlled externally by inputting a VCR activation signal to the [SERIES/CLOCK IN] terminal on
the SR-9240E/EK's rear panel.
To [COM] terminal
Connection
VCR control signal (ground signal)
Start of recording
Operation
VTR MODE 2
(SUMMER TIME)
TERMINAL
(TERMINAL SEL 1)
(TERMINAL SEL 2)
SEL 1
(REC REMAIN))
(COUNT END)
PRESS (SHIFT, SET)
PRESS (MENU) TO END
VTR mode 2 setting screen
• This function has no effect in the Timer Record
Standby mode.
• If a VCR activation signal is input while the unit is
already recording (started with the [REC] button),
recording continues and stops when the activation
signal is no longer input.
38
Rear panel
To [SERIES/CLOCK IN] terminal
LV: 0 V
Stop or power off
OFF
EXT Set to EXT.
WARN
(External
OFF
recording
OFF
function)
External control
equipment
Connect the [SERIES/CLOCK IN] terminal and [COM]
terminal on the SR-9240E/EK's rear panel to the external
control equipment.
1
Set the function menu switch <TERMINAL SEL 1> on
the VTR mode 2 setting screen to "EXT" to use the
external recording function.
2
Press the MENU button to switch the on-screen display
to the time/date display.
3
Load a cassette with a safety tab in place and engage
the Stop mode, the Pause mode or turn the operating
mode off.
• When a VCR activation signal (ground input) is input to
the rear panel's [SERIES/CLOCK IN] terminal,
recording starts automatically and continues for as
long as the activation signal is input.
When the activation signal stops, the Stop or Pause
mode is engaged or the operating mode is turned off
(depending on the VCR status before the external
recording function is used).
• When the activation signal is input again, recording
starts.