Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Vax X-003
Summary of Contents for Vax X-003
-
Page 1: Instruction Manual
X-003 D2.1.qxd 9/9/05 11:13 AM Page 1 Vax Careline: 0870 6061248 www.vax.co.uk Please read carefully before using BAGLESS UPRIGHT VACUUM CLEANER the cleaner. Always fully extend Vax Model Number: X-003/X-003B/X-003T the mains cable before use. Instruction Manual... - Page 2 X-003 D2.1.qxd 9/9/05 11:13 AM Page 2 Parts Overview 1. Diagram FRONT BACK Fig.1/1 Handle grip Dirt container button release Folding handle release knob Crevice tool Dirt container lid Extension tube HEPA filter Hose clip Dirt container Extendable hose Lower hose inspection tube Power cord On/off switch Hose connector...
-
Page 3: Safety Information
IMPORTANT: If the inlet or hose is blocked, switch off dropped into water. Return the vacuum cleaner to the vacuum cleaner and remove the blockage(s) a Vax Authorised Service Agent or suitably before re-starting the vacuum cleaner. qualified person for examination, repair or adjustment. - Page 4 X-003 D2.1.qxd 9/9/05 11:13 AM Page 4 Use & Function 3. Align the tabs on the lower hose/inspection tube 3. Use & Function with the slots on the hose. Push and turn the hose clockwise until secure (Fig.3/3). IMPORTANT: Always remove the power plug from the electrical outlet before assembling or removing accessories.
-
Page 5: How To Operate
The vacuum cleaner must be in the upright position to lift the rotating brushbar off the carpet when cleaning above the floor. Vax recommend that the brushbar height adjust is turned to its highest position when using the tools. - Page 6 X-003 D2.1.qxd 9/9/05 11:14 AM Page 6 Accessories/Dirt Container & Filter: Removal & Replacement 2. Remove the dirt container lid by grasping the dirt 5. Accessories container and turning anti-clockwise (Fig.6/2). Crevice Tool Use the crevice tool for radiators, crevices, corners, skirting boards and between cushions.
- Page 7 X-003 D2.1.qxd 9/9/05 11:14 AM Page 7 Dirt Container & Filter: Removal & Replacement/Rotating Brushbar: Removal & Replacement 7. Rotating Brushbar: NOTE: The white material in the HEPA filter will discolour over time -This is NORMAL and will NOT affect the Removal &...
-
Page 8: Clearing Blockages
X-003 D2.1.qxd 9/9/05 11:14 AM Page 8 Rotating Brushbar: Removal & Replacement/Clearing Blockages Removing Debris from the TurboTool ® 3. Lift the right side of the brushbar and lift the left hand side and remove the brushbar from the power (X-003T only) head (Fig.7/3). -
Page 9: Troubleshooting
X-003 D2.1.qxd 9/9/05 11:14 AM Page 9 Troubleshooting 9. Troubleshooting WARNING: TO REDUCE RISK OF PERSONAL INJURY, UNPLUG VACUUM CLEANER BEFORE SERVICING PROBLEM: Cleaner won’t run Cause: Not properly plugged into electrical outlet. Solution: Plug in firmly. Cause: No electricity in electrical outlet. Solution: Check fuse or breaker. -
Page 10: Technical Specification
Monday-Friday 9.00am to 5.00pm. Motor power: 1200W-1600W An answerphone is available outside of these hours. dependant on model Any queries or concerns about using the Vax, call the Dirt container: 2.9 litres Vax Careline. Calls are charged at the UK national Filter system: Pleated paper HEPA filter rate. - Page 11 X-003 D2.1.qxd 9/9/05 11:14 AM Page 11 This page has been left intentionally blank.
- Page 12 11:14 AM Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility declare that the products X-003/X-003B/X-003T is manufactured in compliance with the following: Safety: 73/23/EEC Low Voltage Directive, as modified by 93/68/EEC EMC: 89/336/EEC Electromagnetic Compatibility Directive, as modified by 93/68/EEC Waste electrical products should not be disposed of with household waste.