Vax X-003 Instruction Manual page 4

X-003 D2.1.qxd 9/9/05
Use & Function
3. Use & Function
IMPORTANT: Always remove the power plug from the
electrical outlet before assembling or removing
accessories.
Tools required: Phillips screwdriver.
1. Insert the handle section into the end port of the
upper cover of the motor and fasten it with screws
on either side of the tube (Fig.3/1).
Fig.3/1
2. Insert the bottom of the dirt container to align with
the tab on the upper cover of the motor. To secure
the dirt container, push the top in place, there will
be an audible click when it is secure (Fig.3/2).
Line up here
Fig.3/2
4
11:13 AM Page 4
Screw
points
3. Align the tabs on the lower hose/inspection tube
with the slots on the hose. Push and turn the hose
clockwise until secure (Fig.3/3).
Fig.3/3
4. Wrap the hose round and through the hose clip
and then down and insert into hose connector
(Fig.3/4).
Fig.3/4