Vax ONE PWR CORDLESS BLADE 4 Series User Manual

Vax ONE PWR CORDLESS BLADE 4 Series User Manual

Cordless

Advertisement

USER GUIDE
CLSV-B4KS
CLSV-B4BS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ONE PWR CORDLESS BLADE 4 Series and is the answer not in the manual?

Questions and answers

Linda Milk
May 1, 2025

No suction except on boost. Have checked each section for blockages

1 comments:
Mr. Anderson
May 16, 2025

Low suction on the Vax CORDLESS BLADE 4 Series vacuum cleaner could be caused by:

1. Blockages in the powered head, reach wand, or handheld connection point.
2. Dirt and debris behind the dirt container flap.
3. A full dirt container.
4. Dirty filters.
5. An obstructed brushbar.
6. The motor thermostat being tripped due to overheating or blockage.

Clearing blockages, emptying the dirt container, and cleaning the filters can help restore suction.

This answer is automatically generated

Subscribe to Our Youtube Channel

Summary of Contents for Vax ONE PWR CORDLESS BLADE 4 Series

  • Page 1 USER GUIDE CLSV-B4KS CLSV-B4BS...
  • Page 2: Safety Guide

    (lighter fluid, petrol, kerosene etc.) or use the machine in an area with DO’S explosive vapours or liquid. • Only VAX ONE PWR batteries • Don’t use the machine to pick up hot (BV15020/BV15030/BV25040) and coals, cigarette butts, matches or...
  • Page 3 BATTERY SAFETY PRECAUTIONS given supervision or instruction • Replace the battery with a VAX concerning use of the machine ONE PWR battery only. Use of in a safe way and understand the another battery may present a risk hazards involved.
  • Page 4: Warranty

    Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. © 2019 VAX Limited. All rights reserved. The VAX trade mark and VAX lozenge are the property of Techtronic Floor Care Technology Ltd and are registered in the EU and may be pending or registered in other countries.
  • Page 5: Getting To Know Your Machine

    Crevice tool Dusting brush Crevice tool storage caddy Wall mount screws and wall plugs TECHNICAL SPECIFICATION VAX ONEPWR Blade 4 Weight (without battery pack) 2.8kg Dirt bin capacity 0.6L Run time and charge time dependent on battery pack and power mode used.
  • Page 6: Getting Started

    GETTING STARTED support.vax.co.uk ASSEMBLY To assemble the dirt container, line up the arrow on the dirt Attach the handheld to the reach wand until it clicks into place. container connection with the arrow on the handle. Push the Attach the reach wand to the powered head until it clicks into dirt container onto the handle until it clicks into place.
  • Page 7: Charging The Battery

    CHARGING THE BATTERY THIS MACHINE IS ONLY TO BE USED WITH VAX ONEPWR BATTERIES AND CHARGER. PLEASE READ THE SAFETY GUIDE BEFORE USE. NOTE: Before first use, ensure the battery is fully charged. Failure to fully charge the battery before first use may result in poor battery performance.
  • Page 8 GETTING STARTED support.vax.co.uk OPERATION Press the on/off button to switch the Press the brushbar on/off button to Press the boost button on to increase machine on. switch the brushbar on. the suction for particularly dirty areas. NOTE: The powered head brushbar should be ON for carpets and OFF for hard floors.
  • Page 9: Cleaning And Maintenance

    CLEANING & MAINTENANCE support.vax.co.uk REMOVING AND REFITTING THE DIRT CONTAINER WARNING: Always remove the battery before carrying out any maintenance or troubleshooting. 1. Squeeze the latch on the dirt To refit, line up the dirt container When correctly fitted all 3 connection container to release.
  • Page 10 CLEANING & MAINTENANCE support.vax.co.uk CLEANING THE FILTER AND SEPARATOR Lift the filter and separator from the Push the tab on the lid of the dirt container and lift the cover to access the filter. dirt container. Tap the separator over a bin to remove...
  • Page 11 CLEANING & MAINTENANCE support.vax.co.uk CLEANING AND REPLACING THE POWERED HEAD BRUSHBAR Press the floorhead release button to Using a coin, push and turn the brushbar lock anticlockwise to release the brushbar. remove the floorhead from the machine. Pull the brushbar out from the brushbar...
  • Page 12 CLEANING & MAINTENANCE support.vax.co.uk CHECKING FOR BLOCKAGES Press the handheld release button and Press the dirt container release button Check the powered head for any remove the reach wand. Check and clear and remove the dirt container. Check blockages and use a blunt object to...
  • Page 13: Troubleshooting

    TROUBLESHOOTING support.vax.co.uk THERE IS AN ACCESSORY MISSING Check the contents on the back of the box. WHY DOES THE MACHINE HAVE NO POWER? • The battery is not fitted correctly. See OPERATION page 7. • The battery has no charge. See CHARGING THE BATTERY page 7.

This manual is also suitable for:

One pwr cordless blade 4 clsv-b4ksOne pwr cordless blade 4 clsv-b4bsBlade 4 clsv-b4ksBlade 4 clsv-b4bs

Table of Contents

Save PDF