Dip Switch Configuration - Lucent Technologies DEFINITY User Manual

Installation
Table 2-1. DIP Switch Configuration
Switch #
1
2
3
4
NOTE:
If you are using a standard central office line, you do not have to
change the factory-set DIP switches. Check with your system
administrator before making any changes. Your system
administrator may have changed DIP switch 3 to the ON
position for normal operation. Do not change this setting without
contacting your system administrator.
2. Connect one end of the line cord provided with the Remote
Module to the telephone company phone jack and the other end
to the LINE jack of the Remote Module.
3. Connect the DEFINITY telephone to the PORT jack of the
Remote Module by using the cord provided with the telephone.
!
CAUTION
Do not plug the line cord provided with the Remote Module
into the PORT jack of the Remote Module. Damage to
circuits may result.
OFF
Normal operation
Normal operation
Normal operation
Normal operation
:
ON
Reserved
Dedicated lines
Reserved
Test mode
Issue 2 July 1997
2-5