16
2. Remove the accent light cover plate from the roof of the firebox. Remove the outer 8 screws, not the
inner 4 screws.
NOTE: When replacing this plate, position the glass to the rear. Make sure the gasket seals tightly
against the firebox ceiling.
3. Pull down the upper accent light enclosure from the roof of the firebox, as shown below. Note the 3
screws holding the bulb assembly in place.
4. Remove the 3 screws holding the bulb assembly in the accent light enclosure. Remove the bulb
assembly from the enclosure.
© Travis Industries
Maintenance
4121206
100-01328