Replacing The O-Rings - Sealife Sea Dragon flash Instruction Manual

XI. Replacing the O-rings
Replace the two O-rings if damaged or at least once per year.
1) Use the O-ring Remover tool
provided to lift and remove
the O-ring.
2) Carefully clean O-ring grooves and O-rings before installation
3) Install O-rings by stretching
and lifting O-ring into the
groove. Do not roll the
O-ring or allow it to twist.
4) Apply a small amount of silicone lube on your finger tip and
wipe it around the O-rings. Wipe off excess lubricant. The o-ring
surface should have shiny, wet appearance.
25