Troubleshooting Guide; Xiv. Troubleshooting Guide - Sealife Sea Dragon flash Instruction Manual

XIV. Troubleshooting Guide

1. External Flash does not fire when pushing TEST button.
a. Power ON flash. Wait until the flash-ready light stops
blinking (steady on). If the ready light does not turn on,
make sure the battery polarity is correct and battery
contacts are clean.
b. Check the battery power. Replace or recharge batteries,
if necessary.
c. If above does not correct the problem, contact your local
SeaLife dealer or SeaLife Service Center in your country.
For a list of dealers, please visit
2. External Flash fires when pushing TEST button, but does not
fire when triggered by camera.
a. Make sure the power switch is set to "ON" position and
the flash-ready light stops blinking (steady on).
b. Take a test pictures and make sure your camera's inner
flash fires.
c. Check that your camera settings are correct Refer to page
13-14 for more information.
d. Make sure the external flash is correctly synched to your
camera. Refer to page 14 for more information.
e. Check that the Flash Link optical cable is attached
correctly. Refer to page 9-12 for more information.
www.sealife-cameras.com.
31