Bandwidth Select (Only Canada models)
All US models are compliants with the
narrowbandwith FCC regulation.
Default setting for Bandwidth Select depends
on the specific frequency and channel. Some
frequencies have selectable channel spacing,
which must match with other radios for
optimum audio quality.
For details, refer to Frequency and Code
Charts section.
Time-Out Timer
When pressing the PTT button, transmissions
will be terminated after a preset time of
continuous transmitting. The default setting
is 60 sec and can be changed using the CPS.
Scramble
The Scramble feature makes transmissions
sound garbled to anyone listening without the
same code. Scramble default value is OFF.
The Scramble feature must be programmed
to SB1 or SB2.
Power Select
Power Select allows you to select between
high and low transmission power per channel.
The power levels for RM Series toggle
between 2W and 1W.
Call Tones
Call Tones feature allows you to transmit an
audible tone to other radios on the same
channel and alerting them that you are about
to talk or alerting them
without speaking. The call tones feature must
be programmed to SB1 or SB2 and 1 of 3 pre-
recorded tones selected
Reverse Burst
Reverse Burst eliminates unwanted noise
(squelch tail) during loss of carrier detection.
You can select values of either 180 or 240 to
be compatible with other radios. Default is
180.
Notes: Some of the features available with the CPS
software may vary depending on the radio
model.
47
English