Example Of Programming Auto-Scan - Motorola RMU2040 User Manual

Example of Programming Auto-Scan

Auto-Scan is the third Programming Mode
and can be set to either ON or OFF on a
particular channel.
To set Auto-Scan to ON:
•
Enter into advanced Configuration Mode and
select the desired channel.
Short press the PTT button three times to enter
•
Auto-Scan Programming Selection Mode. The
radio will announce "Auto-Scan" and current
setting (Enabled or Disabled).
• Short press the SB1 or SB2 buttons to
toggle Enabled/Disabled for the Auto-Scan
feature on the selected channel.
Long press the PTT button. LED Indicator will
•
show a green heartbeat to indicate "Idle" state.
Long press the PTT button to exit
•
Programming Mode or turn radio OFF.
Example of Programming Active Channels
Active Channels is the last Programming Mode and
It allows you to modify the number of active channels
the radio will be programmed to support.
To set Active Channels:
Enter Programming Mode and select the
•
desired channel
Short press the PTT button Four times to enter
•
Active Channels Programming Selection Mode.
The radio will announce "Active Channels" and
•
current value.
Short press the SB1 or SB2 buttons until you
•
hear the number of channels desired.
• Long press the PTT button. LED Indicator will
show a green heartbeat to indicate "Idle" state.
Long press the PTT button to exit
•
Programming Mode or turn radio OFF.
43
English