Blower - Lopi Berkshire Owner's Manual

Optional Equipment
3 8
Blower (part # 99000153)
WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.
1 Attach the two black wires at the rear right of the stove to the thermodisk (orientation does not matter).
Then slide the thermodisk into the holder underneath the burner pan.
2 Place the blower near the rear of the stove. Attach the wiring in grommets following the directions
below.
f
Route the wires labeled "Valve
on/off" and "Solenoid" under
the burner pan to a location
near the gas control valve.
Attach the two wires leading
from the control box to the two
block wires labeled "Rheostat".
Travis Industries
e
d
1 0 0 - 0 1 1 5 9
(for qualified installers only)
Remove one of the screws holding
a
the mounting bracket in place. Insert
the screw through the eyelet on the
green ground wire and replace.
1/4" Nutdriver
c
Attach the molex connector.
Slide the rubber grommets (with
spacers inserted inside) onto the
fan mounting bracket.
Snap Disk Bracket
(attached to stove)
Snap Disk
Snap Disk Wires on Wiring Harness
(Black - orientation does not matter)
Attach the black and white wires
b
labeled "Blower" to the blower
(orientation does not matter).
DO NOT PLUG THE STOVE
IN UNTIL INSTALLATION IS
COMPLETE.
4 0 4 0 6 2 1