Table 9: Ht-496 Advancedc - Grandstream Networks HT-496 User Manual

T 9: HT–496 Advanced Configuration Page Definitions
ABLE
Admin Password
Home NPA
Layer 3 QoS
Layer 2 QoS
STUN Server
Keep-alive interval
Use NAT IP:
Firmware Upgrade
and Provisioning
Firmware Server Path IP address or domain name of firmware server.
Config Server Path
Firmware File Prefix
Firmware File Postfix
Config File Prefix
Config File Postfix
Automatic Upgrade
Firmware Key
On-hook Threshold
FXS Impedance
Grandstream Networks, Inc.
VoIPon www.voipon.co.uk
This contains the password to access the Advanced Web Configuration
page. This field is case sensitive.
Local area code for North American Dial Plan.
This field defines the layer 3 QoS parameter that can be the value used for IP
Precedence or Diff-Serv or MPLS. Default value is 48.
This setting includes two fields. The 802.1Q/VLAN Tag contains the value
used for layer 2 VLAN tag. Default setting is blank. The 802.1p priority
value contains the value of the priority value.
STUN server's IP or FQDN
This parameter specifies how often the HT–496 sends a blank UDP packet to
the SIP server in order to keep the "hole" on the NAT open. Default is 20
seconds. Minimum value is 10 seconds.
NAT IP address used in SIP/SDP message. Default is blank.
Default method is HTTP. Firmware upgrade may take up to 20 minutes
depending on network environment. Do not interrupt the firmware upgrading
process.
IP address or domain name of configuration server.
Default is blank. If configured, HT–496 will request firmware file with the
prefix. This setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is "NO".
When set to No, HT–496 will only do upgrade once at boot up. "Check every
day ", " Check every week", "Always check for New Firmware
" Check New Firmware only when F/W pre/suffix changes"
Used for firmware encryption. Should be 32 digits in Hexadecimal
Representation. End user should keep it blank.
The time hook-flash is pressed that causes the device to on-hook. Default is
800ms.
Selects the impedance of the analog telephone connected to theRJ-11 FXS
port.
HT–496 User Manual
Firmware 1.0.3.64
sales@voipon.co.uk Tel: +44 (0)1245 808195
at Boot up
."
Page 21 of 33
Last Updated: 1/2007
Fax: +44 (0)1245 600030