Advertisement
Operating the Self-Cleaning Double Oven
Note: Upper and Lower Ovens
cannot be self-cleaned at the same
time. However, while self-cleaning
one oven you can use the other one
for baking or broiling.
Before Setting Oven
Controls, Check These
Things:
Step 1:
Remove broiler pan, broiler rack
and other cookware from the oven.
(Oven shelves may be left in oven.
Note: Shelves wiil discolor after
the self-clean cycle.)
Step 2:
Wipe up heavy soil on oven
bottom.
A. Oven Front Frame
B. Oven Door Gasket
C. Openings in Door
D. Rotisserie Receptacle
E. Oven Light
Step 3:
Clean spatters or spills on oven
front frame (A) and oven door
outside gasket (B) with a dampened
cloth. Polish with a dry cloth. Do
not clean gasket (B). Do not allow
water to run down through openings
in top of door (C). Never use a
commercial oven cleaner in or
around self-cleaning oven.
Step 4:
Close rotisserie receptacle (D)
when self-cleaning the upper oven.
Step 5:
Close oven door and make sure
oven light (E) is off.
To Set Your Oven
for Self-Cleaning
Step 1:
Touch the CLEAN pad. Display
shows "CLEAN"
and flashing
indicator points to DOOR LATCH.
If door is not latched within 15
seconds, display reverts to OFF
and you have to start over.
Step 2:
Move door latch all the way to the
right as far as it will go.
To change cleaning time to as
little as 1% hours or as much as 4%
hours, don't touch START pad yet.
First, touch BAKE TIME pad.
. Next, touch Number Pads to enter
the cleaning time. For example, to
enter 2% hours, touch pads 2, 3
and O.
Now touch START to begin
cleaning immediately. Stop Time is
calculated and displayed until
cleaning ends.
Note: You might smell a slight
odor, especially during the first few
cleanings. This is normal during
the self-cleaning cycle and is no
cause for alarm.
When cleaning temperature is
reached, the Indicator Light points
to OVEN LOCKED and the door
cannot be unlatched.
Step 4:
When cleaning is done, the oven
turns off automatically. When it
cools down, which takes about 30
minutes, the OVEN LOCKED
light goes out and the door can be
opened. Unlatch the door by moving
it to the left as far as it will go.
Display shows time of day.
To delay start of cleaning:
(If temperature probe is accidentally
left pluged into the oven receptacle,
display shows "PROB" until you
remove it. Touch CLEAR/OFF pad,
unlatch door and remove probe.
Repeat steps 1 and 2 to reset.)
Step 1:
Touch CLEAN pad and latch door.
Step 3:
Touch START to begin cleaning
immediately. Cleaning cycle takes
three hours and Display Panel shows
Stop Time.
21
Advertisement
