Restarting The Xprintserver; Viewing Logs - Lantronix xPrintServer Network Edition User Manual

Restarting the xPrintServer

The Admin user may use these directions to restart the xPrintServer device through the
xPrintServer user interface and without changing any settings.
1. Login to the xPrintServer user interface (see
2. Click the Admin tab to access the Admin menu. A list of all available Admin user
configuration options appears to the left of the screen (see
3. Click the Restart link on the left side of the page to access the Restart Unit page.
4. Click the Restart Unit button.
5. Click Yes in the confirmation popup that appears (or No to cancel this action).
6. Wait 35 seconds while the unit restarts. The xPrintServer device will restart, bringing you
back to System Status on the Home
access the xPrintServer user interface.

Viewing Logs

The Admin user may use these directions to view logs. xPrintServer user interface provides logs
for all diagnostic and access messages.
1. Login to the xPrintServer user interface (see
2. Click the Logs tab to access the Logs page. A list of all Diagnostic logs appear by default.
3. Click the Access link to the left to view only access logs.
4. Click the Diagnostic link to the left to view only diagnostic logs.
5. Click the Job Status link to the left to view only job status logs.
6. Utilize Navigation
Note: The number of logs on the bottom of the page will update each time the Diagnostic or
Access link on the left is clicked.
xPrintServer User Guide
Page. Authentication
as necessary in situations where there are multiple pages of logs.
Logging In) as the Admin user.
Figure 4-5).
(Logging In) will be required to
Logging In) as the Admin user.
4: Configuration
31