Configuring Printers Through Discovery; Figure 4-1 Printers Auto-Discovered Upon Xprintserver Startup; Figure 4-2 Printer Information - Lantronix xPrintServer Network Edition User Manual


Discovery: The Admin user may activate Discovery at will through the xPrintServer user
interface any time after the xPrintServer is up and running.
Note: Only printers listed among the Lantronix xPrintServer published list of printers will be auto-
provisioned after Discovery (see
servers/supported-printer-list.html). Configuration options to manually add a printer and modify
advanced printer settings are available under Printers > Advanced. Use these advanced options
only if instructed to do so by Lantronix Technical Support.

Configuring Printers through Discovery

The Admin user may utilize the instructions to discover and provision network-connected printers
installed since the xPrintServer last started up or printers on other networks if their IP addresses
have been added (see
1. Login to the xPrintServer user interface (see
2. Click the Printer tab to access the Printer page.

A list of all currently configured printers will be listed on this page.

All printers which were discovered and configured at the xPrintServer startup will also be
listed here with "Auto Discovered" listed under the Location column.
3. Click on any printer to retrieve additional information on that printer. In
second printer in the list was clicked and the printer details in the grey fields below appeared
at the bottom of the list of printers.
Description
Name
IP Address
4. Click the Discovery link to the left of the page. A Printer Auto Discovery Report will
appear showing the date/time the xPrintServer automatically discovered, the number of
configured printers (at the last startup of the device) and associated downloaded drivers.
xPrintServer User Guide
http://www.lantronix.com/it-management/mobile-print-
Adding a Printer IP

Figure 4-1 Printers Auto-Discovered upon xPrintServer Startup

Figure 4-2 Printer Information

Address).
Logging In) as the Admin user.
4: Configuration
Figure 4-2 below, the
Location
Status
21