Honda 08E51-S84-100 Installation Instructions Manual page 5

13. Under the dash on the driver's side of the vehicle,
measure and mark the bottom of the dashboard.
60 mm
30 mm
12 mm
DRILL BIT
14. While wearing eye protection, lightly center-punch
the mark, and drill a 12 mm hole:
• Wrap electrical tape around the end of the
5.5 mm and 12 mm drill bits about 10 mm from
the tip.
• First drill a pilot hole with a 5.5 mm drill bit,
then finish with a 12 mm drill bit.
• Remove all burrs with a file.
15. Route the terminal ends from the disarm switch
through the hole you just drilled, and secure it with
the washer and the 12 mm nut from the kit.
WASHER
12 mm
NUT
DISARM
SWITCH
TERMINAL END
© 2004 American Honda Motor Co., Inc. - All Rights Reserved.
ELECTRICAL
TAPE
10 mm
16. Get the 3-pin connector included in the kit. Firmly
push the disarm switch terminals into the 3-pin
connector until they click into position, then lower
the lock.
BLACK
WIRE
BLUE
WIRE
BLACK WIRE
AII 27627 (0408)
3-PIN
CONNECTOR
3-PIN
CONNECTOR
BLUE WIRE
LOCK
5 of 8