Tools And Supplied Required; Illustration Of Security System Installed On The Vehicle; Adjusting The Control Unit; Sensitivity Adjustment Knob - Honda 08E51-S84-100 Installation Instructions Manual

Wire tie with clip
Antenna bracket
Washer-bolt, 6 x 12 mm
Flange nut, 6 mm
TOOLS AND SUPPLIES REQUIRED
Small flat-tip screwdriver
Phillips screwdriver
Center punch
Eye protection (face shield, safety goggles, etc.)
Drill
5.5 mm and 12 mm Drill bits
Tape measure
File
Felt-tip pen
Ratchet
10 mm, 12 mm, and 14 mm Sockets
Piece of cardboard
Diagonal cutters
Electrical tape
Torque wrench
Illustration of Security System Installed on the
Vehicle
DISARM SWITCH
SECURITY
FUSE
SYSTEM
CASE
HARNESS
(2A)
2 of 8
6-PIN
RELAY
4-PIN
RELAY
CONTROL
UNIT
3429090M
AII 27627 (0408)

Adjusting the Control Unit

Use a small flat-tip screwdriver to change the mode
switch and the horn/siren switch and to adjust
sensitivity. The horn/siren switch must be set in the
"HORN" position.
GLASS
BREAKAGE
SENSOR
SENSITIVITY
ADJUSTMENT
KNOB
MIN MAX
Mode Switch:
• Set the mode switch according to the customer's
choice.
• Refer to the Owner's Manual for the explanation of
each mode.
Glass Breakage Sensor:
Do not attach anything like scotch tape over the
holes; this is a microphone pickup.

Sensitivity Adjustment Knob:

• Adjust the sensitivity only if the customer requests
it; the sensitivity adjustment of the glass breakage
sensor is factory-set.
• Be careful when you adjust the sensitivity; if you
raise the sensitivity too much, the security system
can give a false alarm, and if the sensitivity is too
low, the security system may not work even if glass
is broken.
© 2004 American Honda Motor Co., Inc. - All Rights Reserved.
MODE SWITCH
AUTO LOCK
AUTO
MANUAL
SIREN
HORN