European Community (Ec) Mark Of Conformity Statement; Electrostatic Discharge (Esd); Japanese Electrical Appliance And Material Safety Law Statement; Japanese Power Line Harmonics Compliance Statement - Toshiba SureMark 4610 Service Manual

European Community (EC) Mark of Conformity Statement

This product is in conformity with the protection requirements of EC Council Directive 89/336/EEC on the
approximation of the laws of the Member States relating to electromagnetic compatibility. Toshiba Global
Commerce Solutions cannot accept responsibility for any failure to satisfy the protection requirements
resulting from a non-recommended modification of the product, including the fitting of non-Toshiba Global
Commerce Solutions option cards.
This product has been tested and found to comply with the limits for Class A Information Technology
Equipment according to CISPR 22 / European Standard EN 55022. The limits for Class A equipment were
derived for commercial and industrial environments to provide reasonable protection against interference
with licensed communication equipment.
Warning: This is a Class A product. In a domestic environment this product may cause radio interference,
in which case the user may be required to take adequate measures.

Electrostatic Discharge (ESD)

Attention: Electrostatic discharge (ESD) damage can occur when there is a difference in charge
between the part, the product, and the service person. No damage will occur if the service person and the
part being installed are at the same charge level.
ESD damage prevention
Anytime a service action involves physical contact with logic cards, modules, back-panel pins, or other
ESD sensitive (ESDS) parts, the service person must be connected to an ESD common ground point on
the product through the ESD wrist strap and cord.
The ESD ground clip can be attached to any frame ground, ground braid, green wire ground, or the round
ground prong on the AC power plug. Coax or connector outside shells can also be used.
Handling removed cards
Logic cards removed from a product should be placed in ESD protective containers. No other object
should be allowed inside the ESD container with the logic card. Attach tags or reports that must
accompany the card to the outside of the container.

Japanese Electrical Appliance and Material Safety Law statement

Japanese power line harmonics compliance statement

Cable ferrite requirement

All cable ferrites are required to suppress radiated EMI emissions and must not be removed.
92
SureMark Hardware Service