Safety Training Information - Icom iF5061D Instruction Manual

4

SAFETY TRAINING INFORMATION

Your Icom radio generates RF electromagnetic
energy during transmit mode. This radio is de-
signed for and classified as "Occupational Use
Only", meaning it must be used only during the
course of employment by individuals aware of the
W ARN ING
hazards, and the ways to minimize such hazards.
This radio is NOT intended for use by the "Gen-
eral Population" in an uncontrolled environment.
• For compliance with FCC and IC RF Exposure
Requirements, the transmitter antenna installation
shall comply with the following two conditions:
1. The transmitter antenna gain shall not exceed 0 dBi.
2. IC-F5061/IC-F5061D:
The antenna is required to be located outside of a vehicle and
kept at a distance of 48 centimeters or more between the trans-
mitting antenna of this device and any persons during operation.
For small vehicle as worst case, the antenna shall be located on
the roof top at any place on the centre line along the vehicle in
order to achieve 48 centimeters separation distance. In order to
ensure this distance is met, the installation of the antenna must
be mounted at least 48 centimeters away from the nearest edge
of the vehicle in order to protect against exposure to bystanders.
2. IC-F6061/IC-F6061D:
The antenna is required to be located outside of a vehicle and
kept at a distance of 38 centimeters or more between the trans-
mitting antenna of this device and any persons during operation.
For small vehicle as worst case, the antenna shall be located on
the roof top at any place on the centre line along the vehicle in
order to achieve 38 centimeters separation distance. In order to
ensure this distance is met, the installation of the antenna must
be mounted at least 38 centimeters away from the nearest edge
of the vehicle in order to protect against exposure to bystanders.
19
To ensure that your exposure to RF electromag-
netic energy is within the FCC and IC allowable
limits for occupational use, always adhere to the
following guidelines:
C AU TIO N
• DO NOT operate the radio without a proper antenna attached,
as this may damage the radio and may also cause you to exceed
FCC and IC RF exposure limits. A proper antenna is the antenna
supplied with this radio by the manufacturer or an antenna specifi-
cally authorized by the manufacturer for use with this radio.
• DO NOT transmit for more than 50% of total radio use time ("50%
duty cycle"). Transmitting more than 50% of the time can cause
FCC and IC RF exposure compliance requirements to be ex-
ceeded. The radio is transmitting when the "TX indicator" lights red.
You can cause the radio to transmit by pressing the "PTT" switch.
Electromagnetic Interference/Compatibility
During transmissions, your Icom radio generates RF energy that can
possibly cause interference with other devices or systems. To avoid
such interference, turn off the radio in areas where signs are posted
to do so. DO NOT operate the transmitter in areas that are sensitive
to electromagnetic radiation such as hospitals, aircraft, and blasting
sites.