Three-Way Intercom - Cardo Systems SCALA RIDER G4 POWERSET User Manual

1. While both G4 headsets are turned OFF, turn them ON by pressing and
holding their Mobile Button until their Blue Lights flash three times.
2. Make sure that both headsets are now flashing slowly in Blue.
NOTE: Selecting a CHANNEL that is already in use will override the paired
headset on that CHANNEL with the newly paired headset.
3. On the first G4 headset, press and hold the CHANNEL "A" BUTTON
for at least six seconds until the headset's BLUE or RED Light begins
flashing rapidly, indicating it is in Intercom Pairing mode.
4. Repeat Step 3 for the second headset.
5. Within a few seconds, both headsets will show a solid light for two
seconds, indicating that the two headsets are now paired, con-
nected and ready for use.
NOTE: If the Pairing process is not completed within two minutes the
headset will return to Standby mode.
Initiate Intercom calls
There are two ways to start an Intercom call with your paired headset
while the headset is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an Intercom call will
be established with the other paired headset.
The Intercom call will stay on until all partici-
pants remain silent for 30 seconds.
9.10b. THREE-WAY INTERCOM
Adding a third G4 unit to your PowerSet headsets, allows you to
conduct 3 way intercom conference calls as follows:
16 scala rider G4 PowerSet
® ™
In this configuration Rider "B" is paired to Rider "A" and to Rider "C".
"A" and "C" remain connected to their mobile phones or GPS devices during
Set-up and configuration three-way intercom connectivity
CHANNEL BUTTON
CONNECT:
Tap the chosen
CHANNEL Button once
to add or remove the
other headset from an
Intercom call.
PAIRING BETWEEN THREE PARTICIPANTS (between scala rider
G4 models only)
To add a third G4 unit to your PowerSet headsets, you will need to desig-
nate one of the two factory paired headsets to serve as Rider "B" (see
diagram above). Since the factory paired units use Channel "A", you must
now pair the designated Rider "B" with the third G4 unit (Rider "C").
First G4 unit
Rider "A"
Second G4 unit
IMPORTANT: Since Rider "B" uses two Bluetooth connections during the
conference mode, Rider "B" will be disconnected from the mobile phone
or GPS device until the conference mode is terminated. Upon termination,
Rider "B" will automatically re-connect to his mobile phone or GPS. Rider
the 3-way intercom call.
INTERCOM PAIRING / CONNEC-
CHANNEL TION BUTTON
CHANNEL "A" CHANNEL "A" BUTTON
CHANNEL "B" CHANNEL "B" BUTTON
Third G4 Headset
Rider "C"
Rider "B"
PAIRING MODE LED
INDICATORS
Rapid RED flashing
Rapid BLUE flashing