Using The Headset; Using The Intercom - Cardo Systems SCALARIDER Q2 MULTISET PRO User Manual

REMOVING:
Your headset can be removed for charging
and storage by pressing your finger
gently against the tab and sliding the
headset up with the other hand.
We recommend that you remove the
headset from the helmet when not in
use.

USING THE HEADSET

GENERAL USAGE
GENERAL FUNCTIONS
DESIRED RESULT: REQUIRED ACTION:
Turn on the
Press the CTRL Button steadily for at least three
headset seconds
Turn off the
Press the CTRL Button steadily for at least three
headset seconds
Increase the
Short press the Volume Up Button
volume
Decrease the
Short press the Volume Down Button
volume
AGC (Automatic Gain Control): In addition to manual Volume Control,
the scala rider Q2
will automatically increase and reduce its
pro
volume according to ambient noise and driving speed.
AUDIO SOURCES AND PRIORITIES
The different Audio Sources that are connected to the scala rider Q2
are prioritized as follows:
pro
Highest 1. Mobile phone Audio / GPS device (Incoming/outgoing calls ,
GPS audio and navigation instructions)
2. Primary Buddy Audio and Secondary Buddy Audio
Press here
to remove
Lowest 5. MP3 Connectivity (corded connection)
A high priority Audio Source will always interrupt any lower priority
Audio Source.
Making Intercom calls
3. A2DP audio source
4. FM Radio (built-in)
i.e. Mobile phone call interrupts Intercom call
Intercom call interrupts FM Radio

USING THE INTERCOM

To start a Buddy Intercom call with the Primary Buddy while
the headset is on Standby you can either:
VOICE CONNECT:
Start talking
A Buddy Intercom call will be
established and stay on until
both sides are quiet for 30
seconds.
To start a Buddy Intercom call with the Secondary Buddy
while the headset is on Standby:
MC BUTTON CONNECT:
Double tap the MC Button
A Buddy Intercom call will be established. To end the
Buddy Intercom call, double tap the MC Button again.
NOTE: While the Intercom is on, the Redial and Voice Dial functions will
be disabled
MC BUTTON CONNECT:
or
Single tap the MC Button
A Buddy Intercom call will
be established. To end the
Buddy Intercom call, single
tap the MC Button again.
MC Button
scala rider Q2 MultiSet
® ™
9
pro