Two-Way Intercom; Three-Way Intercom - Cardo Systems SCALA RIDER G4 User Manual

9.10a. TWO-WAY INTERCOM
PAIRING OPTIONS BETWEEN TWO PARTICIPANTS
Your two G4 PowerSet units are factory-paired and configured
to communicate via their respective Channel "A" Buttons. If for any
reason, you have to pair them again, proceed as follows:
1. If either G4 is turned OFF, turn it ON by pressing and holding the
Mobile Button until the Blue Light flashes three times.
2. Make sure that both G4s are now flashing slowly in Blue.
3. Choose an available CHANNEL you wish to use to pair the G4
(CHANNEL "A" or CHANNEL "B").
NOTE: Selecting a CHANNEL that is already in use will override the paired
G4 on that CHANNEL with the newly paired G4.
4. On the G4, press and hold the chosen CHANNEL BUTTON ("A" or
"B") for at least six seconds until the G4's BLUE or RED Light begins
flashing rapidly, indicating it is in Intercom Pairing mode. (See Table
in 9.10).
5. Repeat Step 3-4 for the second G4.
6. Within a few seconds, both G4s will show a solid light for two
seconds, indicating that the two G4s are now paired, connected
and ready for use.
NOTE: If the Pairing process is not completed within two minutes the G4
will return to Standby mode.
Initiate Intercom calls
There are two ways to start an Intercom call with your paired G4 while the
G4 is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an Intercom call
will be established with the other paired G4.
The Intercom call will stay on until all
participants remain silent for 30 seconds.
CHANNEL BUTTON
CONNECT:
Tap the chosen CHANNEL
Button once to add or
remove the other G4 from
an Intercom call.
9.10b. THREE-WAY INTERCOM
Adding a third G4 unit to your PowerSet allows you to conduct
3-way intercom conference calls as follows:
First G4
Rider "A"
In this configuration Rider "B" is paired to Rider "A" and to Rider "C".
IMPORTANT: Since Rider "B" uses two Bluetooth connections during the
conference mode, Rider "B" will be disconnected from the mobile phone
or GPS device until the conference mode is terminated. Upon termination,
Rider "B" will automatically reconnect to his mobile phone or GPS. Rider
"A" and "C" remain connected to their mobile phones or GPS devices
during the 3-way intercom call.
PAIRING OPTIONS BETWEEN THREE PARTICIPANTS (between G4
models only)
To add a third G4 unit to your G4 PowerSet, you will need to
designate one of the two factory-paired G4s to serve as Rider "B" with
the third G4 unit as Rider "C").
Since the factory-paired units use Channel "A", you must now pair the
third G4 unit (Rider "C") on Channel "B".
a. Turn on the designated Rider "B" unit and the Rider "C" unit by
pressing their Mobile Buttons until their blue light flash three times.
Third G4
Rider "C"
Second G4
Rider "B"
scala rider G4 PowerSet
®
17