Using The Headset; Using The Intercom - Cardo Systems Scala-rider Q2 User Manual

SETUP AND CONFIGURATION |

USING THE HEADSET

GENERAL USAGE
GENERAL FUNCTIONS
DESIRED RESULT: REQUIRED ACTION:
Turn on the
Press the CTRL Button steadily for at least three
headset seconds
Turn off the Press the CTRL Button steadily for at least three
headset
seconds
Increase the
Short press the Volume Up Button
volume
Decrease the Short press the Volume Down Button
volume
AGC (Automatic Gain Control): In addition to manual Volume Control,
the scala-rider Q2 will automatically increase and reduce its volume
according to ambient noise and driving speed.
AUDIO SOURCES AND PRIORITIES
The different Audio Sources that are connected to the scala-rider Q2
are prioritized as follows:
Highest 1. Mobile phone Audio / GPS device (Incoming/outgoing calls ,
GPS audio and navigation instructions)
2. Primary Buddy Audio and Secondary Buddy Audio
Lowest 3. FM Radio
A high priority Audio Source will always interrupt any lower priority
Audio Source.
i.e. Mobile phone call interrupts Intercom call
Intercom call interrupts FM Radio
QGQ2_A5_021.indd 7

USING THE INTERCOM

Making Intercom calls
To start a Buddy Intercom call with the Primary Buddy while
the headset is on Standby you can either:
VOICE CONNECT:
Start talking
A Buddy Intercom call will be
established and stay on until
both sides are quiet for 30
seconds.
To start a Buddy Intercom call with the Secondary Buddy
while the headset is on Standby:
MC BUTTON CONNECT:
Double tap the MC Button
A Buddy Intercom call will be established. To
end the Buddy Intercom call, double tap the MC
Button again.
NOTE: When using a scala-rider Headset as a Passenger headset, Voice
Connect Intercom can be initiated only by the scala-rider Q2 headset.
Manual Connect Intercom can be initiated from either headset.
Failed Connection: On the scala-rider Q2, if you attempt to start
a Buddy Intercom call with a Buddy that is already on a Phone/GPS/
Intercom call, you will hear a double beep indicating the Buddy is busy.
Reconnecting the Intercom: If the scala-rider Q2 and its Intercom
Buddy headset go out of range and disconnect from each other, the
scala-rider Q2 will automatically try to reconnect to its Intercom
Buddy for five minutes.
7
scala-rider Q2™ |
or
MC BUTTON CONNECT:
Single tap the MC Button
A Buddy Intercom call will
be established. To end the
Buddy Intercom call, single
tap the MC Button again.
MC Button
2/19/08 1:52:05 PM