Set Up For Rider-To-Passenger Intercom: Pairing - Cardo Systems SCALA RIDER Q2 PRO User Manual

PRIMARY BUDDY PAIRING (requires two
scala rider Q2 headsets*)
pro
1. If either headset is turned OFF, turn it ON by pressing and holding
the CTRL Button until the Blue Light flashes three times.
2. Make sure that both headsets are now flashing slowly in Blue.
3. Pick up one headset and simultaneously press and hold the
CTRL Button and MC Button for at least six seconds until the
Red Light begins flashing rapidly, indicating it is in Intercom
Pairing mode.
4. Repeat Step 3 again for the second scala rider Q2
Both headsets should now be flashing rapidly in Red.
5. Within a few seconds, both headsets will show a solid Red
light for two seconds, and then begin flashing slowly in Blue.
NOTE: If the Pairing process is not completed within two
minutes the headset will return to Standby mode.
* Same process is applicable also for pairing with the Q2, i.e. the predecessor
of the Q2 PRO.
SECONDARY BUDDY PAIRING (requires three
scala rider Q2 headsets*)
pro
Once you have paired your scala rider Q2
Buddy headset, repeat the procedure above to pair your
scala rider Q2 to the Secondary Buddy headset.
pro
NOTE: Your scala rider Q2 is able to communicate with either the Primary
pro
Buddy or the Secondary Buddy. The Primary Buddy and Secondary Buddy are
not able to communicate directly via Intercom.
* Same process is applicable also for pairing with the Q2, i.e. the predecessor
SET UP FOR RIDER-TO-PASSENGER
INTERCOM: PAIRING
There are two ways that the scala rider Q2
Driver-to-Passenger communication.
A. Both Rider and Passenger are using scala rider Q2
headset.
pro
B. The Rider is using a scala rider Q2
to the Primary
pro
NOTES: If the Pairing process is not completed within two minutes
NOTE: If the Pairing process is not completed within two
minutes the headset will return to Standby mode.
of the Q2 PRO.
headsets.
To Pair the two headsets, follow the Steps listed in the section
above titled PRIMARY BUDDY PAIRING (2 bikers).
using an earlier scala rider headset (i.e. a scala rider Solo™,
a scala rider FM™, a scala rider TeamSet™ Driver unit or
TeamSet™ headset).
pro
To Pair the two headsets:
1. Starting with the earlier scala rider headset turned OFF, press
and hold the CTRL button until the Red/Blue lights begin
rapidly alternating.
2. Starting with the scala rider Q2
simultaneously press and hold the CTRL Button and MC
Button for six seconds until the Red light begins flashing
rapidly, indicating it is in Intercom Pairing mode.
3. Within a few seconds, the scala rider Q2
light for two seconds, and then begin flashing slowly in Blue.
the headset will return to Standby mode.
can be used for
pro
pro
and the Passenger is
pro
turned ON,
pro
will show a solid Red
pro
scala rider ® Q2
™
pro
5