VALVE CLEARANCE INSPECTION AND ADJUSTMENT
Adjustment steps:
Adjust the pilot air screw.
●
Refer to "PILOT AIR SCREW ADJUST-
MENT" section.
Turn the throttle stop screw 1 until the
●
specified engine idling speed.
To increase idling speed →
Turn the throttle stop screw 1 in a.
To decrease idling speed →
Turn the throttle stop screw 1 out b.
Inductive tachometer:
YU-8036-B/90890-03113
Engine idling speed:
1,300 ~ 1,500 r/min
VALVE CLEARANCE INSPECTION AND
ADJUSTMENT
NOTE:
The valve clearance should be adjusted
●
when the engine is cool to the touch.
The piston must be at Top Dead Center
●
(T.D.C.) on compression stroke to check or
adjust the valve clearance.
1. Remove:
Seat
●
Fuel tank
●
Refer to "SEAT, FUEL TANK AND SIDE
COVERS" section in the CHAPTER 4.
2. Remove:
Spark plug
●
Intake tappet cover 1
●
Exhaust tappet cover 2
●
O-ring
●
3. Remove:
Timing mark accessing screw 1
●
Crankshaft end accessing screw 2
●
O-ring
●
3 - 12
INSP
ADJ