Error Displays; Specifications - Clarion M502 Owner's Manual & Installation Manual

Bluetooth
Problem Cause
The device does not support the
C a n n o t p a i r t h e
profiles required for the system.
Bluetooth enabled
device with the car
The Bluetooth function of the
audio system.
device is not enabled.
The internal microphone gain is
The audio quality
not set correctly.
is poor after
connection with a
The external microphone is
Bluetooth-enabled
not set correctly nor properly
device.
positioned.
SiriusXM Advisory Messages
Message
Check the SiriusXM tuner connection on the back of the unit to ensure that its correctly
CHEK TUNER
connected.
Ensure the SiriusXM antenna cable is connected to the SiriusXM tuner correctly.
Check the SiriusXM antenna wire for breaks or sharp bends. Replace the antenna if
CHK ANTENA
necessary.
Press RESET located..... If the message remains, the antenna may have been damaged.
The vehicle must be outside, and the antenna must have a clear view of the southern sky.
NO SIGNAL
The magnetic antenna must be mounted on the outside of the vehicle for the best reception.
This channel is not included in your SiriusXM subscription plan.
CHAN UNSUB
Call 1-800-XM-RADIO (1-800-967-2346) to subscribe.
This channel is not a valid SiriusXM channel.
CH UNAVAIL The channel number has been entered incorrectly, or the channel was removed from the
SiriusXM channel lineup
The selected channel has been locked by the parental controls, or a mature channel has
been selected.
CH LOCKED
A prompt to enter the unlock code will appear. Enter the unlock code as described on
page 10.
SUBSCRIPTN
An update to your SiriusXM subscription has been received by the SiriusXM tuner. Press
UPDATED any button to continue.

6. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to solve the problem.
Display Cause
ERROR 2 Do not support iPod & iPhone.
If an error display other than the ones described above appears, press the [RESET] button. If the
problem persists, turn off the power and consult your store of purchase.
* When the [RESET] button is pressed, preset radio stations, titles, etc. stored in memory are kept.
Measure
Use another device to connect.
Refer to the user manual of the device for how to
enable the function.
Adjust the gain of the internal microphone in
System Setup.
Adjust the gain and position of the external
microphone.
For example, stick the microphone onto the
dashboard so it is close to the driver.
Description
Measure
Change another device.
* The head unit will return to RADIO mode.

7. SPECIFICATIONS

FM Tuner
Frequency range: 87.9-107.9MHz
Usable sensitivity: 8dBμ
Frequency response: 30Hz-15kHz
Stereo separation: 30dB(1kHz)
Signal/noise ratio: >55dB
AM Tuner
Frequency range: 530-1710kHz
Usable sensitivity (S/N=20dB): 30dBμ
MP3/WMA mode
MP3 sampling rate: 8 kHz to 48 kHz
MP3 bit rate: 8 kbps to 320 kbps / VBR
WMA bit rate: 8 kbps to 320 kbps
Logical format: ISO9660 level 1,2
Joliet file system
USB
Specification: USB 1.0/2.0
Playable audio format:
MP3(.mp3): MPEG 1/2/Audio Layer-3
WMA(.wma): Ver 7/8/9.1/9.2
Bluetooth
Specification: Bluetooth Ver. 2.0+EDR
Profile: HFP (Hands-free Profile)
A2DP (Advanced Audio Distribution Profile)
AVRCP (AV Remote Control Profile)
PBAP (Phone Book Access Profile)
Send/Receive Sensitivity: Class 2
Audio Amplifier
Maximum power output:
180W (45W x 4)
Speaker impedance: 4Ω (4 to 8Ω allowable)
Input
Audio input sensitivity:
High: 320mV (at 1V output)
Mid: 650mV (at 1V output)
Low: 1.3V (at 1V output)
(input impedance 10 kΩ or greater)
Aux-in level: ≤2V
General
Power supply voltage:
14.4VDC (10.8 to 15.6V allowable),
negative ground
Fuse: 15A
Dimensions of the Main Unit:
188mm Width × 58mm Height × 190mm Depth
7-2/5(width) × 2-7/25(Height) × 7-12/25(Depth)
Weight of the Main Unit: 1.94lb. (0.88kg)
Dimensions of the Remote Control unit:
52mm Width × 7.5mm Height × 85.5mm Depth
2-3/64(Width) × 19/64(Height) × 3-11/32(Depth)
Weight of the Remote Control Unit:
0.77oz. (24g) (including battery)
7" 178mm 2" 50mm
1-4/5" 46mm
6-2/3" 170mm
2-7/25" 58mm
7-2/5" 188mm
Note:
• Specifications and design are subject
t o c h a n g e w i t h o u t n o t i c e f o r f u r t h e r
improvement.
Power Output:
19W x 4 Channels RMS
(4Ω@14.4V≤1% THD+N)
Signal to Noise Ratio:
83 dBA (reference: 1 W into 4 Ω)
M502
15